LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0443 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> Malfunction Indicator Lamp (MIL) Diagnosis >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Any MIL requesting DTCs that may be set should be diagnosed first.

  1. Ignition ON, command the MIL ON and OFF with a scan tool. The MIL should turn ON and OFF as commanded.
  2. Command the MIL ON and OFF with a scan tool while observing the control circuit status parameters listed below:
    • MIL Ckt Short Gnd Test Status
    • MIL Ckt Open Test Status
    • MIL Ckt Short Volts Test Status

      Each parameter should display OK or Not Run.

  3. Engine running, command the MIL ON and OFF with a scan tool while observing the control circuit status parameters listed below:
    • MIL Ckt Short Gnd Test Status
    • MIL Ckt Open Test Status
    • MIL Ckt Short Volts Test Status

      Each parameter should display OK or Not Run.

scientia non olet · About LEMON Manuals