LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0443 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> Inspection/Maintenance System Check >> Conditions for Clearing I/M Test DTCs

Conditions for Clearing I/M Test DTCs

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Only the OBD II System can erase the I/M Test DTC. The OBD II system must determine that the malfunction that caused the I/M Test DTC to be stored is no longer present and is not commanding the MIL. Each of the following represents ways to clear an I/M Test DTC:
    • If the MIL goes out due to 3 passing drive cycles, scan tool code clear is not used, the I/M Test DTC is erased at power down of the last drive cycle.
    • If a scan tool code clear is used to turn OFF the MIL, the I/M Test DTC is not erased, the DTC must PASS and not FAIL. The I/M Test DTC is erased at power down of the drive cycle.
    • If the controller is reflashed/reprogrammed, all I/M Test DTCs are erased.
  2. For the OBD II System to run a single drive cycle for clearing an I/M Test DTC, all of the following conditions must occur:
    • Cumulative time of engine run time is greater than 600 s.
    • Cumulative vehicle operation above 41 km/h (25 mph) for over 300 s.
    • Continuous vehicle idle for greater than 30 s.
    • Turn ignition OFF for 5 s and allow the code to clear.
scientia non olet · About LEMON Manuals