LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0443 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> Fuel System Diagnosis (Without FPCM) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:
    • Inspect the fuel system for damage or external leaks before proceeding.
    • Verify that adequate fuel is in the fuel tank before proceeding.
    • The fuel pump relay may need to be commanded ON a few times in order to obtain the highest possible fuel pressure.
  1. Ignition ON, command the Fuel Pump Relay ON with a scan tool. You should hear the fuel pump turn ON and OFF.
  2. Ignition OFF, all accessories OFF, install the CH-48027 . Refer to Fuel Pressure Gauge Installation and Removal .
  3. Ignition ON, command the Fuel Pump Relay ON with a scan tool. Verify the fuel pressure is between 345-414 kPa (50-60 psi) and remains steady for 5 minutes.
scientia non olet · About LEMON Manuals