LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0443 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> DTC P3401, P3425, P3441, or P3449 >> Typical Scan Tool Data

Typical Scan Tool Data

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Cylinder 1, 4, 6, or 7 Deactivation Solenoid Valve Control Circuit Test Status - Component Commanded OFF

Circuit Short to Ground Open Short to Voltage
Operating Conditions:  Component Commanded OFF
Parameter Normal Range:  The following illustrates the normal parameter state with no circuit conditions:
  • Component OFF - OK for Open/Short to Gnd Test and Not Run for Short to Volts Test
  • Component ON - Not Run for Open/Short to Gnd Test and OK for Short to Volts Test
Ignition Voltage Fault Fault -
Cylinder 1, 4, 6, or 7 Deactivation Solenoid Control Fault Fault Not Run
Cylinder 1, 4, 6, or 7 Deactivation Solenoid Valve Control Circuit Test Status - Component Commanded ON

Circuit Short to Ground Open Short to Voltage
Operating Conditions:  Component Commanded ON
Parameter Normal Range:  The following illustrates the normal parameter state with no circuit conditions:
  • Component OFF - OK for Open/Short to Gnd Test and Not Run for Short to Volts Test
  • Component ON - Not Run for Open/Short to Gnd Test and OK for Short to Volts Test
Ignition Voltage Not Run Not Run -
Cylinder 1, 4, 6, or 7 Deactivation Solenoid Control Not Run Not Run Fault
scientia non olet · About LEMON Manuals