LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0443 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> DTC P3401, P3425, P3441, or P3449 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    DTC P3401, P3425, P3441, and P3449 sets with an open ignition circuit fuse.

  1. Ignition ON, command the appropriate cylinder deactivation solenoid ON and OFF while observing the following status parameters with a scan tool:
    • Cyl. 1, 4, 6, or 7 Deact. Sol. Ckt Open Test Status
    • Cyl. 1, 4, 6, or 7 Deact. Sol. Ckt Short Gnd Test Status
    • Cyl. 1, 4, 6, or 7 Deact. Sol. Ckt Short Volts Test Status

      Each parameter should display OK or Not Run

  2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals