LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0443 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> DTC P0685, P0689, P0690, or P1682 >> Component Testing

Component Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    Depending on the application, the relay coil resistance will be within one of the following ranges.

  1. Test for one of the following resistance specifications between terminals 85 and 86 of the KR75 powertrain relay:
    • 70-110 Ω
    • 200-250 Ω
    • If not within the specified range, replace the KR75 powertrain relay.
  2. Test for infinite resistance between the following terminals of the KR75 powertrain relay:
    • 30 and 86
    • 30 and 87
    • 30 and 85
    • 85 and 87
    • If not the specified value, replace the KR75 powertrain relay.
  3. Install a 20 A fused jumper wire between relay terminal 85 and 12 V. Install a jumper wire between relay terminal 86 and ground. Test for less than 2 Ω between terminals 30 and 87.
    • If greater than the specified range, replace the KR75 powertrain relay.
scientia non olet · About LEMON Manuals