LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0443 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> DTC P0641 or P0651 (ECM) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    Additional DTCs may set when disconnecting components.

  1. Ignition ON, disconnect the harness connector of all the sensors for the applicable DTC. Refer to Diagnostic Aids  for the appropriate sensors.
  2. Ignition ON, measure for 4.8-5.2 V between one of the 5 V reference circuits and ground.
    • If less than the specified range, test for a short to ground on the 5 V reference circuit of each affected component. If all circuits test normal, replace the K20 ECM.
    • If greater than the specified range, test for a short to voltage on the 5 V reference circuit of each affected component. If all circuits test normal, replace the K20 ECM.
    3. NOTE:

    A short to voltage on the signal circuit of certain components may cause this DTC to set.

  3. Connect each component associated with the 5 V reference circuit, one at a time, while monitoring the appropriate scan tool 5 V Reference Voltage parameter. Verify the voltage remains between 4.8-5.2 V.
    • If not the specified range when a component is connected, test the signal circuit for a short to voltage. If the circuit tests normal, replace the appropriate component.
scientia non olet · About LEMON Manuals