LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0443 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> DTC P0601, P0602, P0603, P0604, P0606, P0607, P060D, P062F, or P2610 (ECM) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, clear the DTC information with a scan tool. Observe the scan tool DTC information.
    • If DTC P0602 is set, reprogram the K20 ECM. Refer to Control Module References for K20 ECM replacement, setup, and programming. If DTC P0602 resets, replace the K20 ECM.
  2. Observe the DTC information with a scan tool. Verify that DTC P0601, P0603, P0604, P0605, P0606, P0607, P060D, P062F, or P2610 does not set.
    • If a DTC failed this ignition, replace the K20 ECM.
scientia non olet · About LEMON Manuals