LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 364 (Engine Controls And Fuel - 5.3L, 6.0L & 6.2L - DTC P0443 Through DTC P3449 And Troubleshooting) >> Diagnostic Information and Procedures >> Alcohol/Contaminants-in-Fuel Diagnosis >> Particulate Contaminants in Fuel Testing Procedure

Particulate Contaminants in Fuel Testing Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using an approved fuel container, draw approximately 0.5 liter (0.53 qt) of fuel.
  2. Place the container on a level surface for approximately 5 minutes in order to allow settling of the particulate contamination. Particulate contamination will show up in various shapes and colors. Sand will typically be identified by a white or light brown crystals. Rubber will appear as black and irregular particles.
  3. Observe the fuel sample. If any physical contaminants or water are present, clean the fuel system.
scientia non olet · About LEMON Manuals