LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 362 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Whine/Growl Noise That Changes with Vehicle Speed

Whine/Growl Noise That Changes with Vehicle Speed

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Whine/Growl Noise That Changes with Vehicle Speed

Checks Causes
2-6 and 3-5-R Clutch Hub Thrust Bearing Assembly (65) Inspect the bearing for wear or damage.
Output Carrier Assembly (68)
  • Inspect the carrier assembly for damaged pinion gears, thrust washers, pins, and rollers.
  • Inspect for a damaged center support roller bearing assembly (485).
  • Inspect for damaged thrust bearings (486, 488).
  • Inspect for damaged sun gears (487, 489).
  • Inspect the carrier assembly for damaged output carrier rear sun gear thrust bearing (captured).
  • Inspect for damaged or stripped splines on the output carrier assembly.
Output Carrier Thrust Bearing Assembly (69) Inspect the bearing for wear or damage.
Output Shaft Assembly (70)
  • Inspect for damaged internal gears (495, 497).
  • Inspect the output carrier bushing (498) for damage or wear.
Output Shaft Thrust Bearing Assembly (71) Inspect the bearing for wear or damage.
Input Sun Gear Thrust Washer (55) Inspect the washer for wear or damage.
Input Sun Gear Thrust Bearing (54) Inspect the bearing for wear or damage.
Input Sun Gear (53) Inspect for spline wear or damage.
Input Carrier Assembly (52) Inspect the carrier assembly for damaged pinion gears, thrust washers, pins, and rollers.
1-2-3-4 Clutch Hub Thrust Bearing Assembly (63) Inspect the bearing for wear or damage.
2-6 and 3-5-R Clutch (with Output Carrier Outer Sun Gear Shaft) Hub Assembly (64) Inspect the output carrier inner sun gear shaft bushings (60 and 62) for damage or wear.
Turbine Shaft Thrust Bearing Assembly (57) Inspect the bearing for wear or damage.
Fluid Filter Assembly (26)
  • Inspect for damaged or restricted fluid filter assembly (26)
  • Inspect for damaged fluid filter seal assembly (25) or improper sealing interface (leaks, fluid aeration).
Automatic Transmission Fluid Pump Seal (5) Inspect for worn or damaged seal.
scientia non olet · About LEMON Manuals