LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 362 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Road Test >> Part Throttle Step-In Downshifts

Part Throttle Step-In Downshifts

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the gear selector in the DRIVE position.
  2. Accelerate the vehicle at light throttle (5-15 percent) until 3rd gear is just achieved.
  3. Quickly increase throttle angle until commanded gear indicates that a downshift to 2nd gear is commanded.
  4. Verify that the transmission downshifts within 2 seconds of the throttle movement.
  5. Repeat steps 2 to 4 at higher speed to achieve 4th gear and then step in to command a 4th gear to 3rd gear downshift.
  6. Repeat steps 2 to 4 at higher speed to achieve 5th gear and then step in to command a 5th to 4th gear downshift.
  7. Repeat steps 2 to 4 at higher speed to achieve 6th gear and then step in to command a 6th gear to 5th gear downshift.
  8. Note any harsh, soft or delayed shifts or slipping. Note any noise or vibration.
scientia non olet · About LEMON Manuals