LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 362 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> No Second and Sixth Gear

No Second and Sixth Gear

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
No Second and Sixth Gear

Checks Causes
A/Trans Fluid Pan Assembly (29) Verify proper fluid level and condition, inspect transmission assembly for leaks.
Control Valve Upper Body Assembly (304) Inspect for sticking, damaged, or worn 2-6 clutch regulator valve (334) and spring (326).
Control Solenoid (w/Body and TCM) Valve Assembly (314) Pressure control solenoid 4 commanded/failed LOW (off) or leaking - Perform solenoid valve assembly function test. Refer to Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test .
Center (with 2-6 Low and Reverse Clutch) Support Assembly (67)
  • Inspect for proper installation of the 2-6 clutch return spring retaining ring (455).
  • Inspect for damaged 2-6 clutch piston assembly (457), spring (456), retaining ring (455), and center support housing (459).
  • Inspect for worn or damaged 2-6 clutch plates (451-453).
Center Support Fluid Passage Seal Assembly (20)
  • Inspect for worn, cut, or damaged seals.
  • Inspect for proper seal (20) size (6L45/50E MYA/MYB) vs (6L80/90E MYC/MYD).