Conditions for Running the DTC
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
P2714
- No other ECM or TCM DTCs are set.
- The accelerator pedal position is 0.5 percent or greater.
- The output speed is 16 RPM or greater.
- The ignition voltage is 8.6 volts or greater.
- The engine speed is 400 RPM or greater for 5 seconds.
- The transmission temperature is -6.6°C (20°F) or greater.
- The throttle position signal is valid.
- High side driver (HSD) is enabled.
- The PC solenoid 4 is commanded ON, applying the 2-6 clutch.
P2715
- No other ECM or TCM DTCs are set.
- The accelerator pedal position is 0.5 percent or greater.
- The output speed is 16 RPM or greater.
- The ignition voltage is 8.6 volts or greater.
- The engine speed is 400 RPM or greater for 5 seconds.
- The transmission temperature is -6.6°C (20°F) or greater.
- The throttle position signal is valid.
- High side driver (HSD) is enabled.
- The PC solenoid 4 is commanded OFF, releasing the 2-6 clutch.