LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 362 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0842 or P0843 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    You must perform the Circuit/System Verification first.

  1. Ignition OFF. Remove the Q8 control solenoid valve assembly. Refer to Control Valve Body Assembly Removal .
  2. Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection .
  3. Place the Q8 control solenoid valve assembly on a clean work surface near the transmission assembly.
  4. Connect the DT-47825-10  jumper harnessbetween the vehicle wire harness electrical connector, and the Q8 control solenoid valve assembly electrical connector.
  5. Ignition ON, verify with a scan tool that each TFP switch parameter changes states when gently pushing on each TFP switch with the eraser end of a pencil.
    • If any TFP switch parameter does not change states, replace the Q8 control solenoid valve assembly.
scientia non olet · About LEMON Manuals