LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 362 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0815, P0816, P0826, or P1876 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the automatic transmission shift lever harness connector.
  2. Ignition ON, verify with a scan tool the Tap Up/Down Switch parameter displays OFF in the Chassis Data list under BCM.
  3. Ignition ON, test for greater than 11 volts between the ignition voltage circuit terminal 4 and ground at the battery negative post.
    • If less than the specified value, test the ignition voltage circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  4. Ignition OFF, test for 6.6-7.0 K ohms between terminal 3 and terminal 4 on the automatic transmission shift lever harness connector. Also, test for 3.7-4.2 K ohms when pressing the minus (-) switch and 1.7-2.0 K ohms when selecting the plus (+) switch.
    • If not within the specified values, replace the automatic transmission shift lever.
  5. Test the signal circuit between the BCM and the automatic transmission manual shift switch for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
scientia non olet · About LEMON Manuals