LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 362 (Automatic Transmission - 6L80/6L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0562 or P0563 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X1 16-way harness connector at the transmission.
  2. Connect the DT-47825-10  harnessto the X1 16-way vehicle harness connector.
  3. Test for less than 5 ohms between terminal 5 and ground at the transmission case.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  4. Ignition ON, verify that a test lamp illuminates between the ignition voltage circuit and B+ circuit terminals listed below and ground.
    • Terminal 4 and ground at the transmission case
    • Terminal 12 and ground at the transmission case
    • If the test lamp does not illuminate, test the ignition circuit or B+ circuit for a short to ground or an open/high resistance.
  5. If all circuits test normal, replace the Q8 control solenoid valve assembly.
scientia non olet · About LEMON Manuals