Circuit/System Testing
WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
- Observe the 4WD Signal in the ECM Data List. The 4WD signal should display Enabled when you shift into 4WD and Disabled when you shift into 2WD.
- If the scan tool display does not match the transfer case range switch state, repair the transfer case system refer to Diagnostic Starting Point - Vehicle .
- If the scan tool matches the transfer case range switch state, continue with testing.
- If the DTC is set, program the T6 power inverter module. If the DTC resets, replace the T6 power inverter module.