LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 361 (Automatic Transmission - 2ML70 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Automatic Transmission Overheating >> Diagnostic Fault Information

Diagnostic Fault Information

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Cause DTCs
Engine: 
  • Engine coolant level low
  • Incorrect engine coolant
  • Old coolant or incorrect concentration level
  • Cooling system leak
  • Radiator hose kinked or pinched
  • Loose, missing, or damaged radiator air seals or deflector - restricted air flow
  • The radiator and A/C condenser has air flow obstructions to include large amount of bent fins
  • The cooling fans do not operate
  • Inspect the engine mechanical for worn, leaking, cracked cylinder heads, or engine block
P1258
Transmission: 
Vehicle Overload or Beyond Capacity Towing:
  • Vehicle is overloaded
  • Vehicle is towing beyond capacity
  • Towing in wrong gear
  • Vehicle modifications
P0218
Heat Transfer:
  • Engine overheating
  • Cooler restrictions - radiator has restricted flow/blockage
  • Restricted air flow
  • Vehicle modifications
  • Aftermarket auxiliary cooler installed incorrectly, incorrect flow direction - reversed flow
  • Restricted, blocked, or pinched transmission cooler lines.
  • Stuck open or stuck closed transmission cooler line thermostat
P0218
Transmission Abuse:
  • Engine overheating
  • Excessive brake torque maneuvers
  • Vehicle overloaded
  • Vehicle is towing beyond capacity
  • Vehicle modifications
P0218
Vehicle Damage:
  • Damage to vehicle under carriage
  • Transmission bottom pan damage
  • Restricted air flow
P0218
Transmission Fluid:
  • Fluid leaks
  • Low fluid level
  • Contaminated or poor transmission fluid quality
P0218
Low Fluid Pump Output:
  • Low fluid level
  • Blocked, damaged or loose filter
  • Pinched or restricted cooler lines
  • Restricted cooler - damage or debris
  • Inefficient pump - worn
P0218
Clutch Slippage:
  • Low fluid level
  • Low Fluid Pump Output
    • Damaged or leaking clutch seals
    • Internal hydraulic leak
    • Worn clutch plate assembly
P079A
P079B
P079C
P079D