Front Output Shaft Drive Sprocket Bearing Replacement
WARNING: This page is about a different car, the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP. Front Output Shaft Drive Sprocket Bearing Replacement
| Callout |
Component Name |
|
Preliminary Procedure
- Using the J 35512
bearing installer and an arbor press, remove the bearing assemblies from the drive sprocket.
- Ensure the bearings are installed squarely into the drive sprocket bore.
- Install the bearings from the top with the clutch teeth facing down.
Special Tools J 35512
Inner Pinion Bearing Installer |
| 1 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Front
- Install the bearing using the long side of the DT-48211
bearing installer.
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211
Drive Sprocket Bearing Installer
- J 8092
Universal Driver
- J 35512
Inner Pinion Bearing Installer
For equivalent regional tools, refer to Special Tools . |
| 2 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Rear
- Install the bearing using the short side of the DT-48211
bearing installer.
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211
Drive Sprocket Bearing Installer
- J 8092
Universal Driver
- J 35512
Inner Pinion Bearing Installer
|