LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Transfer Case - Mp 3010-NP0) >> Diagnostic Information and Procedures >> DTC P2160 or P2161 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the VSS resistance is within the specified range.
  2. Using a terminal test kit, connect the DMM between the VSS high signal and the VSS low signal circuits at the VSS connector. Raise and support the drive wheels. While rotating the drive wheels by hand ensure the AC voltage reading on the DMM is above 0.4 volt.
    • If the AC voltage is not above 0.4 volt, replace the VSS.
scientia non olet · About LEMON Manuals