LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Transfer Case - Mp 3010-NP0) >> Diagnostic Information and Procedures >> DTC C0396 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different car, the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

C0396 01 

Voltage on incremental encoder sensor 8 V supply circuit greater than 9.0 V.

C0396 02 

Incremental encoder sensor 8 V supply circuit less than 1.5 V, or voltage on incremental encoder impulse signal circuit or incremental encoder direction signal circuit less than 0.5 V.

C0396 04 

Voltage on encoder 8 V supply circuit is 1.5-9.0 V and voltage read by low reference circuit less than 0.3 V.

C0396 05 

Voltage on encoder signal circuits less than 0.3 V or greater than 4.6 V.