LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Transfer Case - Mp 3010-NP0) >> Diagnostic Information and Procedures >> DTC C0396 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

TCEM - Incremental Position Sensor

  1. Set parking brake.
  2. Block wheels.
  3. Remove the encoder motor from transfer case. Using a paint pen or marker, place indexing marks on the shift detent lever receiver and the mounting surface of the encoder motor.
  4. Connect encoder motor to engine harness.
  5. Key ON, engine OFF.
  6. Transmission in Neutral.
  7. Attach scan tool. Clear codes. DTC C0569-4B may remain in memory.
    8. NOTE:

    You must perform the Transfer Case High/Low Clutch Reset  procedure after performing the next step.

  8. Monitor the following parameters while using the Transfer Case Motor Control function of the Special Function feature of the scan tool to command the encoder motor forward and reverse. The parameters should display as shown.
    • If the parameters do not display as described, replace the encoder motor assembly.
Parameter Range Forward Reverse Notes
Incremental Position Sensor (°) -150°/+360° -150° or 360° 360° or -150° Alternate between -150° and 360°
Incremental Position Sensor (V) 7.0-8.0 V 7.0-8.0 V 7.0-8.0 V Value constant when commanded forward or reverse
Incremental Sensor Direction Clockwise/ Counter Clockwise Counter Clockwise Clockwise Scan tool may not read correctly if C0306 or C0396 are in memory.
Incremental Sensor Direction (V) 0.70-4.3 V 0.7-0.8 V 4.1-4.3 V -
Incremental Impulse Sensor (V) 0.70-4.3 V Varies Varies Varies when commanded forward or reverse

TCCM

  1. Key OFF. Disconnect the TCCM X1 connector.
  2. Key ON, engine OFF. Connect the EL-49742  harness.
  3. Test for 7.5-8.5 V between the incremental encoder sensor (8 V) supply pin, TCCM X1-9, and the ground terminal of the EL-49742  harness, black terminal.
    • If the outside the specified range, replace TCCM.
  4. Test for 7.5-8.5 V between the incremental encoder sensor (8 V) supply pin, TCCM X1-9, and the low reference pin, TCCM X1-10.
    • If the outside the specified range, replace TCCM.
  5. Test for 6.0-7.0 V between the incremental encoder impulse signal pin, TCCM X1-3, and the ground terminal of the EL-49742  harness, black terminal.
    • If the outside the specified range, replace TCCM.
  6. Key OFF. Connect the TCCM X1 connector. Disconnect the TCCM X2 connector.
  7. Key OFF. Test for a diagnostic B+ (+0.0/-1.0 V) between the incremental encoder direction pin, TCCM X2-14, and the B+ terminal of the EL-49742  harness, red terminal.
    • If the outside the specified range, replace TCCM.
  8. Go to Circuit/System testing.
scientia non olet · About LEMON Manuals