Service Parts Release Usage Change - NQH/NPO Control Actuator Levers

WARNING: This page is about a different car, the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Components

Courtesy of GENERAL MOTORS CORP.

Light Duty (LD) 2007-2010 MP3023-NQH and 2010 MP3010-NP0 production transfer cases are built with LD control actuator levers (3 and 6) and are used with 13 mm (0.52 in) diameter control actuator lever balls (5)

Heavy duty (HD) 2007-10 MP3024-NQH production transfer cases are built with HD control actuator levers (3 and 6) and are used with Heavy 10 mm (0.39 in) control actuator lever balls.

When replacement of one or both of the LD control actuator levers is required, it is necessary to replace both of the levers and all three balls with the HD components as a set. It is also necessary to re-measure and adjust clutch pack clearances as required and to perform the Transfer Case High/Low Clutch Reset. Refer to Measuring/Adjusting Clutch Assembly Height in Transfer Case Assemble, Transfer Case Description and Operation and Transfer Case High/Low Clutch Reset. Heavy duty (HD) components are the only parts available for service.