LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 357 (Engine Controls And Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Fuel Pump Flow Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Pump Flow Control Module And Bolts
    GM1911342Courtesy of GENERAL MOTORS CORP.
  1. Position the fuel pump flow control module (2) to the vehicle.
  2. Slide the fuel pump flow control module towards the driver side of the vehicle.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Tighten the fuel pump flow control module bolts (1).

    Tighten 

    Tighten the bolts to 9 N.m (80 lb in).

    4. Fig 2: Chassis Wiring Harness Electrical Connector
    GM1911337Courtesy of GENERAL MOTORS CORP.
  4. Connect the chassis wiring harness electrical connector (1) to the fuel pump flow control module.
    5. Fig 3: ECBM Shield, Retainers And Bolts
    GM1964016Courtesy of GENERAL MOTORS CORP.
  5. Position the EBCM shield (1) to the underbody and install the EBCM shield bolts (3).

    Tighten 

    Tighten the bolts to 20 N.m (15 lb ft).

  6. Install the EBCM shield retainers (2).
  7. Lower the vehicle.
  8. Program the fuel pump flow control module. Refer to Control Module References .
scientia non olet · About LEMON Manuals