LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 357 (Engine Controls And Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister, Bracket And Bolt
    GM1964900Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister (2) to the bracket (3).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the EVAP canister bolt (1).

    Tighten 

    Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: EVAP Canister Assembly
    GM1964898Courtesy of GENERAL MOTORS CORP.
  3. Position and install the EVAP canister assembly (2) to the fame bracket tab.
  4. Install the EVAP canister bolts (1).

    Tighten 

    Tighten the bolts to 25 N.m (18 lb ft).

    5. Fig 3: Quick Connect Fittings
    GM1964897Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP pipe quick connecting fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Connect the fuel tank EVAP line quick connect fitting (2) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  7. Connect the fuel tank EVAP line quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals