LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 357 (Engine Controls And Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: CKP Sensor And Bolt
    GM1239292Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the CKP sensor bolt.

    Tighten 

    Tighten the bolt to 25 N.m (18 lb ft).

    3. Fig 2: Knock Sensor Wiring Harness Electrical Connector
    GM1964987Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
  4. Position the engine wiring harness sleeve (2) over the CKP sensor electrical connection.
  5. Lower the vehicle.
  6. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About LEMON Manuals