Electronic Suspension Front Position Sensor Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Electronic Suspension Front Position Sensor

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
1	Front Position Sensor Link TIP: Disconnect the link from the sensor ball stud.
2	Front Position Sensor Bolt CAUTION: Refer to Fastener Caution . Procedure Remove the bolt from the sensor. Tighten 12 N.m (106 lb in)
3	Front Position Sensor Procedure Program the electronic suspension control module. Refer to Control Module References .