LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 348 (Power Outlets) >> Repair Instructions >> Cigar Lighter Receptacle or 12-Volt Accessory Power Receptacle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Cigar Lighter Socket/Accessory Power Outlet
    GM1235275Courtesy of GENERAL MOTORS CORP.
  1. Remove the auxiliary power outlet fuse from the fuse block.
  2. Remove the receptacle:
    1. Look into the receptacle. There are two 3 mm (0.11 in) tab windows 12 mm (0.47 in) from the front of the receptacle. The J 42059  pushes the plastic latches from these tab windows and the receptacle can be pulled straight out.
    2. Place one side of the "T" portion of the J 42059  into the tab window. The J 42059  will not fit straight into the receptacle. Angle the J 42059  slightly for insertion into the receptacle.
    3. Insert the other side of the "T" into the opposite tab window.

      You must move the J 42059  handle toward horizontal to engage the other tab window.

    4. Use the J 42059  to pull the receptacle straight out.
    3. Fig 2: Cigar Housing & Grinding Tool
    GM1120988Courtesy of GENERAL MOTORS CORP.
  3. If J 42059  tool fails to release the lighter socket from the retainer, perform the following alternate method:
    1. Insert a small grinding tool with a cutoff wheel into the socket.
    2. Remove the plastic latches in the 3 mm (0.11 in) square windows.
    3. Use the J 42059  as directed above to remove the socket.
scientia non olet · About LEMON Manuals