LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 347 (Hybrid/EV Control System) >> Diagnostic Information and Procedures >> DTC P0A45, P0A46, P0C57, P0C58, P0C61, P0C62, or P1B04 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    You must perform the Component Testing before proceeding with Circuit/System Testing.

  1. Ignition OFF, disconnect the X176 harness connector at the transmission.
  2. Install the DT-48493  jumper harness to the vehicle harness side only.
  3. Ignition ON, test for 0.8-1.4 V between the terminals listed below and ground:
    • Terminal 17
    • Terminal 18
    • Terminal 20
    • Terminal 21
    • If not within the specified range, test the signal circuit for a short to voltage, short to ground, or an open/high resistance. If the circuit tests normal replace the T6 power inverter module.
  4. Ignition ON, test for 6.5-7.5 V between the terminals listed below and ground:
    • Terminal 15
    • Terminal 16
    • If not within the specified range, test the signal circuits for a short to voltage, short to ground or an open/high resistance. If the circuits test normal replace the T6 power inverter module.
scientia non olet · About LEMON Manuals