LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Upper Intake Manifold Sight Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Manifold Sight Shield Retainer Bolts
    GM1696801Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  1. Position the intake manifold sight shield on top of the intake manifold, aligning the holes, if required.
  2. Install the intake manifold sight shield retainer bolts, if required.

    Tighten 

    Tighten the bolts to 5 N.m (44 lb in).

    3. Fig 2: Upper Intake Manifold Sight Shield
    GM1696760Courtesy of GENERAL MOTORS CORP.
  3. Install the intake manifold sight shield tabs into the slots in the retainer.
  4. Align the intake manifold sight shield grommets with the studs.
  5. Gently push down on the intake manifold sight shield over the grommets, seating the intake manifold sight shield.
  6. Close the hood.
scientia non olet · About LEMON Manuals