LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Upper Intake Manifold Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Booster Vacuum Hose
    GM1697051Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement (RPOs LC9, LMG, LY5, L76) , Intake Manifold Replacement (RPOs LY2, LY6) , Intake Manifold Replacement (Except RPOs LY2, LY6, LC9, LMG, LY5) .
  2. Reposition the brake booster vacuum hose clamp at the intake manifold.
  3. Remove the brake booster vacuum hose from the intake manifold nipple.
    4. Fig 2: Upper Intake Manifold Cover And Nut
    GM1697057Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper intake manifold cover nut.
  5. Remove the upper intake manifold cover.
scientia non olet · About LEMON Manuals