LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Left Side (L96) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will result in a damaged oil pickup unit.

  1. Remove the left engine mount bracket. Refer to Engine Mount Bracket Replacement - Left Side (L96) .
    2. Fig 1: View Of Engine Mount To Engine Bolts
    GM1701899Courtesy of GENERAL MOTORS COMPANY
  2. Working through the wheelhouse opening, remove the engine mount to engine block bolts (1).
  3. Using the adjustable jack, raise the engine slightly until there is enough clearance to remove the engine mount.
    4. Fig 2: View Of Engine Mount
    GM1701901Courtesy of GENERAL MOTORS COMPANY
  4. Remove the engine mount through the rear of the wheel well opening.
scientia non olet · About LEMON Manuals