LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Drive Belt Replacement - Accessory >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drive Belt (4.8L, 5.3L, 6.0L And 6.2L Engines)
    GM833370Courtesy of GENERAL MOTORS CORP.
  1. Open the hood.
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  3. Install a breaker bar with hex-head socket to the drive belt tensioner bolt.
  4. Rotate the drive belt tensioner clockwise in order to relieve tension on the belt.
  5. Remove the drive belt (1) from the pulleys and the drive belt tensioner.
  6. Slowly release the tension on the drive belt tensioner.
  7. Remove the breaker bar and socket and from the drive belt tensioner bolt.
  8. Clean and inspect the belt surfaces of all the pulleys.
scientia non olet · About LEMON Manuals