LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drive Belt Idler Pulley
    GM678804Courtesy of GENERAL MOTORS CORP.
  1. Position the drive belt idler pulley to the generator bracket and tighten the idler pulley bolt finger tight.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Tighten the drive belt idler pulley bolt.

    Tighten 

    Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals