LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Oil Pan-To-Rear Oil Seal Housing Bolts
    GM680413Courtesy of GENERAL MOTORS CORP.
  1. Remove the automatic transmission flexplate. Refer to Automatic Transmission Flex Plate Replacement .
  2. Remove the oil pan-to-rear oil seal housing bolts (1).
    3. Fig 2: Rear Oil Seal Housing Components
    GM2100849Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear oil seal housing bolts (1).
  4. Remove the rear oil seal housing (2) and gasket (3). Discard the gasket.
  5. Remove and discard the rear oil seal (4).
scientia non olet · About LEMON Manuals