LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Housing Replacement >> Installation Procedure - Cover without Seal

Installation Procedure - Cover without Seal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Oil Seal Housing Components
    GM2100849Courtesy of GENERAL MOTORS CORP.
  1. Position a NEW rear oil seal housing gasket (3) and the housing (2) to the engine.
  2. Install the rear oil seal housing bolts (1) until snug. Do not overtighten.
  3. Rotate the crankshaft until 2 opposing flywheel bolts holes are parallel to the oil pan surface.
    4. Fig 2: Housing Alignment Tool
    GM451716Courtesy of GENERAL MOTORS CORP.
    NOTE:

    The tapered legs of the alignment tool must enter the rear cover oil seal bore.

  4. Install the J-41476  tool and bolts onto the rear of the crankshaft.
  5. Tighten the J-41476  tool bolts until snug. Do not overtighten.
    6. Fig 3: Oil Pan-To-Rear Oil Seal Housing Bolts
    GM680413Courtesy of GENERAL MOTORS CORP.
  6. Install the oil pan-to-rear oil seal housing bolts (1).
    1. Tighten the oil pan-to-rear cover bolts to 12 N.m (106 lb in).
    2. Tighten the rear oil seal housing-to-engine bolts to 30 N.m (22 lb ft).
  7. Remove the J-41476  tool.
  8. Install a NEW crankshaft rear oil seal. Refer to Crankshaft Rear Oil Seal Replacement .
  9. Install the automatic transmission flexplate. Refer to Automatic Transmission Flex Plate Replacement .
scientia non olet · About LEMON Manuals