LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Front Oil Seal Replacement (With LY6) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Do not lubricate the oil seal sealing surface.
  • Do not reuse the crankshaft front oil seal.
    Fig 1: Crankshaft Front Oil Seal
    GM1658279Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the outer edge of the oil seal (140) with clean engine oil.
  2. Lubricate the front cover oil seal bore with clean engine oil.
    3. Fig 2: Front Oil Seal And Special Tool
    GM1658280Courtesy of GENERAL MOTORS CORP.
  3. Install the crankshaft front oil seal (140) onto the J 41478  Crankshaft Front Oil Seal Installer guide.
  4. Install the J 41478  Crankshaft Front Oil Seal Installer threaded rod (with nut, washer, guide, and oil seal) into the end of the crankshaft.
  5. Use the J 41478  Crankshaft Front Oil Seal Installer in order to install the oil seal into the cover bore.
    1. Use a wrench and hold the hex on the installer bolt.
    2. Use a second wrench and rotate the installer nut clockwise until the seal bottoms in the cover bore.
    3. Remove the J 41478  Crankshaft Front Oil Seal Installer.
    4. Inspect the oil seal for proper installation. The oil seal should be installed evenly and completely into the front cover bore.
  6. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
scientia non olet · About LEMON Manuals