LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Camshaft Position Actuator Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the starter. Refer to Starter Replacement .
    2. Fig 1: Flywheel Holding Tool
    GM1658136Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  2. Install the J 42386-A  holding tool (1) and bolts. Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation. Tighten the J 42386-A  holding tool bolts to 50 N.m (37 lb ft).
  3. Remove the camshaft position (CMP) actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement .
    4. Fig 2: CMP Actuator Solenoid Valve
    GM1670622Courtesy of GENERAL MOTORS CORP.
    WARNING:

    Refer to Camshaft Position Actuator Removal and Installation Warning .

  4. Remove the CMP actuator solenoid valve (234).
  5. Discard the solenoid valve.
scientia non olet · About LEMON Manuals