LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Engine Mechanical - 5.3L, 6.0L & 6.2L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Flex Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Flex Plate And Bolt
    GM832979Courtesy of GENERAL MOTORS CORP.
  1. Remove the automatic transmission. Refer to Transmission Replacement for the 6L45/6L50/6L80/6L90 transmission.
    2. NOTE:

    Note the position and direction of the engine flywheel before removal.

  2. Remove the flywheel bolts.
  3. Remove the flywheel.
    4. Fig 2: Bolts And Spacer
    GM642281Courtesy of GENERAL MOTORS CORP.
  4. Install two M11x1.5 mm bolts (1) to the threaded holes of the spacer, if applicable.
  5. Rotate the bolts clockwise to remove the spacer.
    6. Fig 3: Crankshaft Spacer
    GM642276Courtesy of GENERAL MOTORS CORP.
  6. Remove the spacer from the rear of the crankshaft, if applicable.
scientia non olet · About LEMON Manuals