Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Belt

Courtesy of GENERAL MOTORS CORP.

NOTE:

The OEM replacement stretchy belt is packaged with a disposable installation tool.

Position the belt behind the rear face of the balancer (1) and off of the A/C pulley (2).
Install the belt installation tool (3) onto the balancer.

Fig 2: Belt Installation Tool

Courtesy of GENERAL MOTORS CORP.

Slide the belt installation tool (1) upward, installing the belt (2) onto the belt installation tool.
Slide the belt installation tool downward, positioning the belt onto the A/C pulley, applying light tension to the belt.

Fig 3: Locating Lower Portion Of Belt & Ribbed Area Facing Forward

Courtesy of GENERAL MOTORS CORP.

Position the lower portion of the belt (1) with the ribbed area facing forward.

Fig 4: Rotating Crankshaft Pulley

Courtesy of GENERAL MOTORS CORP.

Slowly rotate the crankshaft pulley (1) in a clockwise direction while using finger pressure to pull the belt (2) forward. Ensure that the ribbed area of the belt remains facing forward and the belt aligns properly to the A/C pulley.

Fig 5: Drive Belt Alignment

Courtesy of GENERAL MOTORS CORP.

Inspect the drive belt (1) for proper installation and alignment.

Fig 6: A/C Compressor Drive Belt

Courtesy of GENERAL MOTORS CORP.

Rotate the balancer (1) and additional 360 degrees to ensure proper belt installation.
Install the skid plate. Refer to Engine Shield Replacement .
Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .