LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 343 (Wheel Drive Shafts) >> Diagnostic Information and Procedures >> Clunk Noise When Accelerating During Turns

Clunk Noise When Accelerating During Turns

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Clunk Noise When Accelerating During Turns

Step Action Yes No
1 Check for worn or damaged outer wheel drive shaft joints and/or seals.
Are the outer wheel drive shaft joints/seals worn?		 Go to Step 2  System OK
2 Check for proper clearance between the wheel drive shaft and other components. Correct as necessary.
Is the repair complete?		 System OK Go to Step 3 
3 Replace the outer CV joints/seals. Refer to Wheel Drive Shaft Outer Joint and Boot Replacement .
Is the repair complete?		 System OK -
scientia non olet · About LEMON Manuals