Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Position the steering gear in the vehicle and support it with jackstands.
- Install the steering gear bolts (1) at the right side of the steering gear and tighten to 100 N.m (74 lb ft).
- Install the steering gear bolts (1) to the left side of the steering gear and tighten to 200 N.m (148 lb ft).
- Connect the steering linkage outer tie rods (1) to the steering knuckles.
- Install the new steering linkage outer tie rod nuts and tighten to 60 N.m (44 lb ft).
- Connect the steering shaft coupling to the steering gear.
- Install the steering shaft coupling bolt (1) at the steering gear and tighten to 47 N.m (35 lb ft).
- Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
- Perform the high voltage enabling procedure. Refer to High Voltage Enabling .
- Perform the power steering control module setup procedure. Refer to Power Steering Control Module Programming and Setup .
CAUTION:
Refer to Fastener Caution .
NOTE:
Start all steering gear bolts by hand before finalizing the torques.