LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 342 (Power Steering System) >> Repair Instructions >> Steering Gear Replacement (Recirculating Ball Without LMM) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pitman arm if necessary. Refer to Pitman Arm Replacement .
  2. Position the steering gear in the vehicle.
    3. Fig 1: Steering Gear Bolts
    GM1864179Courtesy of GENERAL MOTORS CORP.
    NOTE:

    Start all of the steering gear bolts by hand and fully seat the bolts before finalizing the torque.

  3. Install the steering gear bolts (1).
    4. CAUTION:

    Refer to Fastener Caution .

  4. Tighten the steering gear bolts to 150 N.m (110 lb ft).
    5. Fig 2: Pitman Arm Nut
    GM1864181Courtesy of GENERAL MOTORS CORP.
  5. Connect the pitman arm to the relay rod.
  6. Install the pitman arm nut (1) and tighten to 62 N.m (46 lb ft).
  7. Connect the power steering hoses to the steering gear. Tighten the hose fittings to 32 N.m (24 lb ft).
  8. Connect the steering shaft coupling to the steering gear. Refer to Steering Shaft Coupling Replacement .
  9. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  10. Lower the vehicle.
    11. Fig 3: Locking Steering Column
    GM333146Courtesy of GENERAL MOTORS CORP.
  11. Remove the J-42640  Pin from the steering column.
  12. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
  13. Remove the drain pans.
  14. Clean any excess fluid from the vehicle.
scientia non olet · About LEMON Manuals