LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 342 (Power Steering System) >> Repair Instructions >> Steering Gear Pitman Shaft Seal and Bearing Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Needle Bearing Into Steering Gear Housing
    GM740400Courtesy of GENERAL MOTORS CORP.
  1. Install the steering gear pitman shaft bearing into the steering gear housing (1) using J 6278  pitman shaft bearing remover and installer.
  2. Drive the steering gear pitman shaft bearing into the steering gear housing until the shoulder seats properly.
    3. Fig 2: Steering Gear Housing Components
    GM412382Courtesy of GENERAL MOTORS CORP.
  3. Coat the steering gear pitman shaft seal (2) and steering gear pitman shaft washer (3) with grease.
  4. Install the steering gear pitman shaft seal (2) into the steering gear housing (1) using J 6219  pitman shaft oil seal installer.
  5. Install the steering gear pitman shaft washer (3) onto the steering gear housing (1).
    6. Fig 3: Pitman Shaft Retaining Ring And Steering Gear Housing
    GM412380Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:

    The steering gear pitman shaft seal must not contact the steering gear pitman shaft bearing.

  6. Install the steering gear pitman shaft seal retaining ring (2) into the steering gearing housing (1) using J 4245  internal snap ring pliers.
    7. Fig 4: View Of Pitman Arm, Shaft Boot, Shaft Dust Seal And Steering Gear Housing
    GM740399Courtesy of GENERAL MOTORS CORP.
  7. Coat the dust seal (2) with grease and install it into the steering gear housing (1).
  8. Install the pitman arm boot (3) onto the steering gear housing (1).
    9. IMPORTANT:

    Do not install the pitman arm until all components have been installed onto the steering gear housing.

  9. Install the steering gear pitman shaft and housing cover. Refer to Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle .
  10. Install the pitman arm (4) to the steering gear (1). Refer to Pitman Arm Replacement .
  11. Adjust the steering gear pitman arm shaft over center pre-load as needed. Refer to Steering Gear Pitman Shaft Over-Center Preload Adjustment - Off Vehicle .
  12. Install the steering gear. Refer to Steering Gear Replacement (Recirculating Ball Without LMM) , Steering Gear Replacement (Two Mode Hybrid) , Steering Gear Replacement (Hydraulic Rack and Pinion) .
scientia non olet · About LEMON Manuals