LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 342 (Power Steering System) >> Repair Instructions >> Steering Gear Boot Replacement (Without HP2) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
    2. Fig 1: Steering Linkage Inner Tie Rod And Nut
    GM1759516Courtesy of GENERAL MOTORS CORP.
  2. Remove the steering linkage inner tie rod nut (2) from the steering linkage inner tie rod (1).
    3. Fig 2: Rack & Pinion Boot And Clamp
    GM1759500Courtesy of GENERAL MOTORS CORP.
  3. Remove the outer boot clamp (2) from the steering gear boot (1).
    4. Fig 3: Rack And Pinion Boot And Boot Clamp
    GM1759493Courtesy of GENERAL MOTORS CORP.
  4. Remove the inner boot clamp (1) from the steering gear boot (2) with side cutters.
  5. Discard the inner boot clamp.
  6. Remove the steering gear boot from the steering gear.
scientia non olet · About LEMON Manuals