LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 342 (Power Steering System) >> Repair Instructions >> Steering Gear Boot Replacement (HP2) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
  2. Remove the steering linkage inner tie rod nut from the steering linkage inner tie rod.
    3. Fig 1: Inner Tie Rod, Boot And Clamp
    GM461496Courtesy of GENERAL MOTORS CORP.
  3. Remove the outer boot clamp (2) from the steering gear boot (3).
  4. Remove the inner boot clamp from the steering gear boot.
  5. Remove the steering gear boot from the steering gear (5).
scientia non olet · About LEMON Manuals