LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 342 (Power Steering System) >> Repair Instructions >> Power Steering Pump Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Power Steering Pump Drive Shaft Seal
    GM1555824Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the new power steering pump shaft seal with power steering fluid.
  2. Use a deep 1 inch tall socket in order to install the new power steering pump shaft seal.
  3. Install the power steering pump. Refer to Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) .
scientia non olet · About LEMON Manuals