LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 342 (Power Steering System) >> Repair Instructions >> Power Steering Pump Pulley Replacement (4.3L, 4.8L, 5.3L, 6.0L, 6.2L) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine coolant fan upper shroud, if equipped. Refer to Engine Coolant Fan Upper Shroud Replacement (Mechanical) .
  2. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
    3. Fig 1: Power Steering Pump Pulley Remover
    GM649303Courtesy of GENERAL MOTORS CORP.
  3. Use remover J 25034-C  to remove the power steering pump pulley.
scientia non olet · About LEMON Manuals