LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 342 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Reservoir Replacement - Off Vehicle >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Reservoir O-ring Seals
    GM404947Courtesy of GENERAL MOTORS CORP.
  1. Clean and install the power steering fluid reservoir magnet (3).
  2. Install the power steering pump seals (1, 4, 5) to the power steering pump (2).
  3. Fig 2: Reservoir Assembly And Pump Housing Assembly
    GM404931Courtesy of GENERAL MOTORS CORP.
  4. Connect the power steering fluid reservoir (1) and the power steering pump (2).
  5. Fig 3: Pump Housing & Flow Control Valve And Spring
    GM404928Courtesy of GENERAL MOTORS CORP.
  6. Install the power steering pump flow control valve spring (3) and the power steering pump flow control valve (2) to the power steering pump assembly (1).
  7. Fig 4: Connector And Fitting Assembly
    GM404915Courtesy of GENERAL MOTORS CORP.
  8. Install the power steering pump fitting seal (3) to the power steering pump assembly (1).
  9. CAUTION:

    Refer to Fastener Caution .

    NOTE:

    Start the power steering fluid reservoir studs and the power steering pump flow control valve fitting by hand before finalizing any torques.

  10. Install the power steering pump fitting (4) to the power steering pump assembly (1).

    Tighten 

    Tighten the fitting to 75 N.m (55 lb ft).

  11. Install the power steering fluid reservoir studs (2) to the power steering pump assembly (1).

    Tighten 

    Tighten the studs to 58 N.m (44 lb ft).

  12. Install the power steering pump assembly to the vehicle. Refer to Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) .