LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 342 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Cooler Replacement (Without Hydroboost) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering fluid cooler to the vehicle.
    2. Fig 1: Power Steering Cooler To Core Support
    GM686121Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  2. Install the power steering fluid cooler bolts (2) to the power steering fluid cooler (1).

    Tighten 

    Tighten the bolts to 9 N.m (80 lb in).

    3. Fig 2: Power Steering Pump And Components
    GM1861214Courtesy of GENERAL MOTORS CORP.
  3. Connect the power steering fluid cooler hose (3) to the power steering pump (1).
  4. Connect the power steering gear outlet hose (2) to the power steering fluid cooler (4).
  5. Clean any excess fluid from the vehicle and remove the drain pans.
  6. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
  7. Install the radiator grille reinforcement support, if equipped. Refer to Radiator Grille Reinforcement Support Replacement .
  8. Install the fascia grille. Refer to Fascia Grille Replacement (Z71) , Fascia Grille Replacement (Escalade) , Fascia Grille Replacement (GMC Denali XL) , Fascia Grille Replacement (Suburban, Tahoe) , Fascia Grille Replacement (GMC Yukon Hybrid 2 Mode) , Fascia Grille Replacement (Yukon) .
scientia non olet · About LEMON Manuals